Dell OptiPlex 3020M Owner's Manual page 37

Table 3. System Configuration (continued)
Option
Miscellaneous Devices
Table 4. Video
Option
Multi-Display
Table 5. Security
Option
Admin Password
System Password
Internal HDD-0 Password
Strong Password
Password Configuration
Password Bypass
Password Change
Description
This option is enabled by default.
These fields let you enable or disable various on board devices.
Description
This option enables or disables Multi-Display. It should be enabled for Windows 7 32/64-bit
only.
Default setting: Disabled
Description
Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard drive
password. Deleting the admin password automatically deletes the system password and
the hard drive password.
NOTE: Successful password changes take effect immediately.
Default Setting: Not set
Allows you to set, change or delete the system password.
NOTE: Successful password changes take effect immediately.
Default Setting: Not set
This field lets you set, change, or delete the administrator (admin) password (sometimes
called the setup password). The admin password enables several security features.
● Enter the old password
● Enter the new password
● Confirm the new password
Default Setting: Not set
Enable strong password - This option is disabled by default.
This field controls the minimum and maximum number of characters allowed for the admin
and system passwords.
● Admin Password Min
● Admin Password Max
● System Password Min
● System Password Max
Allows you to bypass the System Password and the internal HDD password prompts during
a system restart. This option is disabled by default.
● Disabled - Always prompt for the system and internal HDD password when they are set.
● Reboot Bypass - Bypass the password prompts on restarts (warm boots).
NOTE: The system will always prompt for the system and internal HDD passwords
when powered on from the off state (a cold boot). Also, the system will always prompt
for passwords on any module bay HDDs that may be present.
Allows you to determine whether changes to the system and hard disk passwords are
permitted when an administrator password is set.
● Allow Non-Admin Password Changes - This option is enabled by default.
Nastavení systému 37