Installing the PS2 and Serial Connector Board
1. Place the PS2 and serial connector board into its slot.
2. Tighten the screws that secure the PS2 and serial connector board to the base panel.
3. Connect the cable to the PS2 and serial connector board.
4. Install the cover.
5. Follow the procedures in
Removing the WLAN Card
1. Follow the procedures in
2. Remove the:
a.
cover
b.
hard drive
3. Perform the following steps as shown in the illustration:
a. Remove the screw that secures the WLAN card to the system board [1].
b. Remove the WLAN bracket from the system board [2].
c. Disconnect the WLAN cables [3].
d. Slide the WLAN card from the system board [4].
28
Demontáž a montáž součástí
After Working Inside Your
Before Working Inside Your
Computer.
Computer.