DBL Technology GoIP-1 User Manual page 22

https://arttel.ru/
DBL Technology Co., Ltd.
www.dbltek.com
to be connected.
LAN Port
There are 3 access methods available to configure the LAN port.
1. Static IP – This mode applies to both public
and private IP network environment. In
the LAN port configuration shown on the
left, select "Static IP" and then fill in the
parameters as provided by your network
administrator.
2. DHCP (default setting) – When the device is installed behind
NAT and a DHCP host is available, select "DHCP" to enable
the device to obtain LAN IP address and other network information automatically.
3. PPPoE – ADSL and Cable modems very often use PPPoE dial
up to obtain network IPs. If this is the case, select "PPPoE"
and then enter the information as provided by your ISP.
PC Port
The PC Port allows other network devices to be attached to the device in order get network connection. It
offers both Router and Bridge modes to meet your requirements.
1. Static IP (default setting) – This mode enables the device
to create another network segment and it then functions
as a router/gateway for this new network segment.
Select "Static IP" for this new segment and then enter
the PC port IP address and Subnet Mask accordingly.
It also has a built-in DHCP server to assign IPs to the
devices attached to this network segment.
and then enter the "Starting Address", "Ending Address",
and "Static DNS" as required.
As a factory default, the PC port is set to "Static IP" (Router mode) with IP Address set to 192.168.8.1 and
Subnet Mask to 255.255.255.0.
2. Bridge Mode – Select this mode if your network topology
requires the network devices attached to the PC port to
be in the same network segment as the LAN port.
Advanced Features
1. VLAN – This is a type QoS service and is intended to give higher transmission priority to real time packets.
However, your router switch and ISP network need to support this feature as well.
https://arttel.ru/shop/gsm-shlyuzy/gsm-shlyuz-goip-4
Technical Support: support@dbltek.com
Enable it
GoIP User Manual
22