When A Printer Error Occurs - Epson SC-F3000 Series Manual

SC-F3000 Series How to Replace the Print Head

When a Printer Error Occurs

See the following table and take the appropriate actions for the printer error code (6-digit number shown at the bottom
of the screen).
If printer error codes that are not shown in the following table appear, see the User's Guide (Online Manual).
Printer error number
002100
002200, 002201, 002205, 002207
002202, 002204, 002208, 002209,
00220A
002203
00220D
Problem Solver
What to do
Turn off the printer, and then restart it in User Self Repair Mode.
"How to Start in User Self Repair Mode" on page 9
U
The connector may not be connected correctly to the Print Head.
Turn off the printer, reconnect the connector correctly, and then start the printer again in
User Self Repair Mode.
"Replacement Procedure" on page 13
U
"How to Start in User Self Repair Mode" on page 9
U
Contact your dealer or Epson Support for assistance. Tell them the printer error code is
"XXXXXX".
A Print Head has been installed that is not for the printer.
Turn off the printer, and then replace the Print Head with one that is for the printer.
"Replacement Procedure" on page 13
U
Do not reuse the Print Head that was mistakenly installed. The colors of ink could mix and
harden, resulting in lower quality. Handle it the same way as a used Print Head.
"About Used Print Heads" on page 22
U
After finishing the replacement, start the printer in User Self Repair Mode.
"How to Start in User Self Repair Mode" on page 9
U
The carriage cover may not be installed correctly.
Turn off the printer, install the carriage cover correctly, and then start the printer again in
User Self Repair Mode.
"Replacement Procedure" on page 13
U
"How to Start in User Self Repair Mode" on page 9
U
28