Process After Replacement - Epson SC-F3000 Series Manual

SC-F3000 Series How to Replace the Print Head
G
Put the temporary platform back, and secure it
with a screw (1 pc).
Use your fingers to tighten the screw until it stops
turning.
H
Align the carriage cover with the protrusions on
the printer to install it.
Confirm that the protrusions stick out of the
holes near the screw holes.
I
Turn the screws (4 pc) clockwise to secure it.
User your fingers to tighten the screws until they
stop turning.
Replacement Procedure
Tighten the screws in order in a diagonal pattern.
J
Close the left side of the printer cover.
Dispose of any Used Print Heads
U
Process after
Replacement
This section explains how to fill a Print Head with ink
and confirm it was replaced correctly.
A
Check that an M size platen without a grip pad is
installed.
There should be nothing on the platen.
B
Connect the power cable to an electrical outlet.
C
Start the printer in User Self Repair Mode.
U
page 9
The ink starts filling.
D
Mark guidelines for the position on the platen to
set the film, as shown in the illustration.
21
"About Used Print Heads" on page 22
"How to Start in User Self Repair Mode" on