Table Of Contents; Specified Conditions Of Use; General Safety Instructions - Elektro Maschinen basic Series Operating Instructions Manual

Table of Contents

1. Components and Parts
2. Please Read First!
3. Range of Application
and Media
4. Safety
4.1Specified conditions of use
4.2General Safety Instructions
5. Prior to Operation
5.1 Installation
5.2 Connecting the Suction Line
5.3 Discharge Port
5.4 Connection to a Pipe System
5.5 Connection to AC Power 5.6
Filling the pump and priming
6. Operation
6.1 Commissioning
7. Care and Maintenance
7.1 Checking the tank's
precharge pressure
7.2 Danger of freezing
7.3 Pump Dismounting and
Storing
8. Troubleshooting
8.1 Fault finding
8.2 Adjusting the Pressure
Switch
8.3 Increasing the Precharge
Pressure
9. Repairs
10. Environmental Protection
2. Please Read First!
These instructions are written
in a way that will enable you
to safely use the machine in a
minimum of time.
instructions should be used as
follows:
Read these instructions in full
before
operating. Pay special attention
to the safety information.
These instructions are
intended for persons having a
basic technical knowledge in
the handling of machines such
as the one described here. If
you have no expe-rience with
this type of pump you are
strongly advised to seek
competent advise and
guidance from an experienced
person before operating this
pump.
Keep all documents supplied
with the pump for future
reference. Retain proof of
purchase for possi-ble warranty
claims.
If you hire out or sell this
machine be sure to hand over
the machine doc-uments
supplied.
The equipment manufacturer
is not liable for any damage
arising from disregard of these
instructions.
The information in these
instructions is marked as
under:
Danger!
Warning
personal injury or
environmental
damage.
Risk of electric hock!
Risk of personal
injury by electric
shock.
Caution!
Risk of material
damage
Note:
These
Additional information.
Numbers in illustrations
(1, 2, 3, ...)
indicate component parts;
are consecutively numbered;
refer to the corresponding num-
bers in brackets (1), (2), (3) ...
in the neighbouring text.
EN
Instructions to be carried out in
sequence are numbered.
Instructions which can be carried
out in any sequence are preceded
by a bullet (•).
Listing are preceded by a M-
dash (-).
3.
This equipment is intended for
pumping clear water in domestic
applications, such as
irrigation,
well, rain and service water pumping
draining of pools, garden ponds
and water tanks.
The max. permissible temperature of
the pumped medium is 35 °C.
4. Safety
4.1
Explosive, inflammable, aggressive
flu-ids or substances detrimental to
health and salt water must not be
pumped.
This equipment is not suitable for
com-mercial or industrial use.
Alteration of the equipment or use
of parts not approved by the
of
equipment manufacturer is not
permitted.
Any other used is not as specified.
The manufacturer assumes no
liability for damage caused by
unspecified use.
4.2
This equipment can be used by
children of 8 years and older and by
people with limited physical, sensory
or mental capacities or those with no
experience and knowledge if they are
supervised or have re-ceived
instruction in how to use the
equipment safely and understand the
dangers which result from such use.
Children are not allowed to play with
the equipment. Unless supervised,
children are not allowed to clean the
equipment and carry out user-level
maintenance work.
Range of Application and
Media

Specified conditions of use

General Safety Instructions

3 2