Assembly Instructions With Exploded Diagrams - Christopeit Sport AL 1 Assembly And Exercise Instructions

Assembly Instructions
Remove all the separate parts from the packaging, lay them on the floor
and check roughly that all are there on the base of the assembly steps.
Please note that a number of parts have been connected directly to
the main frame and preassembled. In addition, there are several other
individual parts that have been attached to separate units. This will make
it easier and quicker for you to assemble the equipment.
Assembly time: 30 - 40 min.
Step 1:
Attach the stabilizer (20+27) at main frame (1).
1. Put the end caps with transportation roller (18) at the ends of front foot
(20) in appropriate position and screw them tightly by using screw (71).
2. Attach the short front foot (20) with the preassembled end caps with
transportation rollers (18) to the main frame (1). Do this with the two
screws (28), washers (13), spring washers (37) and cap nuts (19).
3. Put the end caps with height adjustment (26) at the ends of rear foot
(27) and screw them tightly by using screw (71).
4. Attach the longer rear foot (27) to the main frame (1). Do this with the
two screws (28), washers (13), spring washers (37) and cap nuts (19).
After assembly has been completed, you can compensate for minor
irregularities in the floor by turning the wheel at cap (26). The equipment
should be set up that the equipment does not move of its own accord
during a training session. If you like to change the position of the home
bike, put one foot in front of the front foot (20) and pull at handlebar in
front direction until the home bike can move easy on the transportation
rollers to another place.
Step 2:
Attach the pedals (22L+22R) at pedal crank (21L+21R).
1. Screw the right pedal (22R) into the locator in the right-hand side (as
seen in operation) for the pedal crank (21R) (warning! the screw direction
is clockwise).
2. Screw the left pedal (22L) into the locator in the left-hand side (as seen
in operation) for the pedal crank (21L)
(Warning! the screw direction is anti-clockwise).
3. Then mount the pedal straps left and right on the associated pedals
(22). (The pedals are signed with „L" for Left and „R" for Right.)
(Note: The end with many adjustable holes must be set outwards.)
17