Dorma Compact Slide CS Manual

Compact Slide CS
1.TechnIcal data for the control
system
. M81navobge: Appliance connector, 230V 150Hz
Fua:
T2A fin.rwire fuse
Motor connection:
GR 53><58 motor
Incremental encoder: Connection lor the incremental
encoder on 1I1e motor drive shalt
Servtce pullhbutlona: 513" a learning cycle.
Opening pulse
OperaIlng dlsplaya: Ug,t signal dunng operation or
leaming cycle
The two PhOnixconnectors on 1I1e right-lland side have 1I1e
following PIN nos. end coding
Upper I""el
13
Lower Level
• =
Set Pin position
••• To make the Interface connections In thecontrol unit,
La
s 2 mm ftat-tlppedacrewdrlver
1.1 Terminal assignment
Programme 8Wllch I key 8Wllch
5-GND
6 - NIGHT I BANK
7-GND
8 - Programme switch: PERMANENT OPEN - Input
9 - Programme switch: PARTIAL OPENING -Input
10 - Programme switch: EXIT ONLY
11 - Programme swnch: AUTOMATIC
12 - Progremme switch: OFF
SpeclallunctJons, potential,,",,,
13-GND
14 -Alncx:k
15-GND
16 - Emergency (panic) closing
17 - Door status (potential.free contact)
18 - Door status (potential-free contact)
19 - Bell (potential-free contact)
20 - Bell (porentiaHree contect)
5erIa1interlaces
l-GND
2-BU5A
3-BU5B
4-+24V
Mains
C5=230V/AC
[l]
Is required.
- input
, Input
- Input
' Input
contacts
,Input
-Input
-Output
-Output
-Output
, Output
The connectora on the left-hand skle hIIv. no
extra martdnga, as from here to the emergency
atop no cablea will be connected, but only
cables with end ntlIngs will be Inserted •
Incremental encoder
f>-wtrf connector for 1I1e connoction 01an Incremental encoder
cable.
Dlstrtbullon PCB
26-way oonnectDrlor the connection of a nbbon cable.
EInef\I8nCY atop
2-way connector; jumper if connection is not assigned.
Motor
2-way connector; counterpart to be found on motor c;abk,.
~
DORMA
-3-