Level: "Power" Tab - Siemens SIMATIC IPC427E Operating Instructions Manual

2.6.3

Level: "Power" tab

Device behavior after a power failure and after a "wake event".
Calling "Power" tab
Select: "Setup Utility (Page 9)" > "Power".
Firmware setting Value
Wake on LAN 1 Disabled
(X1 P1)
Enabled
Wake on LAN 2 Disabled
(X2 P1)
Enabled
Wake on LAN 3
Disabled
(X3 P1)
Enabled
PROFINET always On
Disabled
Enabled
USB Ports 1/2
Disabled
(X61/X60)
Enabled
USB Ports 3/4
Disabled
(X63/X62)
Enabled
USB Ports Disabled
5/6(MCP/OTC)
Enabled
USB Ports 9 Disabled
(Front USB)
Enabled
USB Port 10
Disabled
(internal)
Enabled
Touch Controller Ignored
Mode
Singletouch
• Only with:
Multitouch
IPC477E
Firmware/BIOS Description SIMATIC IPC427E, IPC477E
Operating Instructions, 07/2020, A5E50262994-AA
Setting in Meaning
delivery
state
IPC427E
IPC477E
The LAN controller of the onboard Ethernet interface "X1 P1" can-
not switch on the device.
x The LAN controller of the onboard Ethernet interface "X1 P1" can
switch on the device.
The LAN controller of the onboard Ethernet interface "X2 P1" can-
not switch on the device.
x The LAN controller of the onboard Ethernet interface "X2 P1" can
switch on the device.
The LAN controller of the onboard Ethernet interface "X3 P1" can-
not switch on the device.
x The LAN controller of the onboard Ethernet interface "X3 P1" can
switch on the device.
x The onboard PROFINET interface of CP1616 is not supplied with
power in the operating states S4 and S5.
The onboard PROFINET interface of CP1616 is supplied with pow-
er in the operating states S4 and S5.
The respective USB ports are not supplied with voltage in sleep
mode.
x The respective USB ports are supplied with voltage in sleep mode.
x The respective USB ports are not supplied with voltage in sleep
mode.
The respective USB ports are supplied with voltage in sleep mode.
x The respective USB ports are not supplied with voltage in sleep
mode. (only available on IPC477E)
The respective USB ports are supplied with voltage in sleep mode.
(only available on IPC477E)
x The respective USB port is not supplied with voltage in sleep
mode. (only available on IPC477E)
The respective USB port is supplied with voltage in sleep mode.
(only available on IPC477E)
x The respective USB port is not supplied with voltage in sleep
mode.
The respective USB port is supplied with voltage in sleep mode.
x Touch controller is disabled.
Touch controller is operated in single-touch mode.
Touch controller is operated in multi-touch mode.
Configure firmware
2.6 "Power" tab
25