Krups Grind & Brew KM8328 Manual page 18

3. Wipe down the housing with a damp cloth. If necessary, use a little mild detergent if
necessary.
4. Check the mains cable regularly for any damage.
Cleaning the Grinder Shaft
1. Remove the coffee beans from the coffee bean box (B). (Apart from the few beans that
you cannot reach by hand.)
2. Insert a basket filter paper into the filter insert.
3. Press the button to switch on the appliance. The grinding process will start.
4. Once the rest of the coffee beans have been ground – you can tell this from the change
in the grinding noise – stop the grinding process by pressing the button again.
Unplug the Appliance
5. Take out the coffee bean box: To do this, turn it a little anticlockwise until it disengages
(fig.7). Lift it off.
6. Move the grinding fineness dial to the "Open" position.
7. Pull out the top part of the grinder (D).
8. Clean the grinder shaft and the grinder with cleaning brush.
9. Reinsert the top part of the grinder and press it down. Make sure it is in the correct
position (arrow marking). Fold the handle down again.
10. Adjust the grinding fineness dial back to a grinding fineness. The grinder is locked again.
11. Place on the coffee bean box at an angle and turn it clockwise a little until it engages.
12. Dispose the filter paper and clean Grind and brew basket (C).
DESCALING CYCLE
1. Fill water tank with descaling solution (or vinegar).
2. Press Descaling button (H9). Descaling indicator (G6) appears on the display.
3. Press On/Off button (H1) to start the descaling cycle:
– On/Off indicator (H2) flashes
– Descaling indicator (G6) flashes
– Hot descaling solution goes across the empty filter holder
4. When the descaling cycle is finished:
– On/Off indicator (H2) switches off
– Descaling indicator (G6) stops and disappears
Note:
„ Descaling cycle can last longer.
„ After the descaling cycle, launch 2 cycles using tankful clear water (10 cups) to rinse the
machine.
Problem
The coffee does not brew
or the appliance does not
turn on.
The appliance seems to leak.
18
TROUBLESHOOTING
„ Make sure the appliance is well connected to a working outlet and that it is in
the "ON" position.
„ The water tank is empty.
„ There is a power outage.
„ Unplug the machine, then plug it back in.
„ The clock should be reprogrammed after a power outage.
„ Make sure the water tank has not been filled beyond the maximum limit.
„ Make sure the water tank is not damaged.
Solutions