Before Weighing; Select Channel; Select The Weighing Mode; Checking The Weighing Mode - RDS Technology Weighlog 200 User Manual

3.

Before Weighing

3.1

Select Channel

Ensure that the correct channel is selected
for the attachment / commodity / trailer to
be weighed.
Simply press the
through the channels.
3.2

Select the Weighing Mode

In the normal operating mode, you cannot
switch
weighing mode on an individual channel.
Separate channels are set up for either
Static weighing or Dynamic weighing, as
part of the weight calibration routine
(6.2.4). You then select the appropriate
channel for the weighing mode you wish
to use.

Checking the Weighing Mode.

1. HOLD the
instrument (Fig. 4). The display will show
"dYn" for dynamic weighing mode or
"StAt" for static weighing mode, for
channel 1.
2. Press the
other channels.
between Static
button and power-on the
button to cycle through the
button to cycle
and Dynamic
PRELIMINARY SETTINGS
Figure 3 Select Channel
Figure 4 Enter CAL Mode 1
Figure 5 Select Weighing Mode
ON
9