3M™ Digital Projector DX70i
Warning: Lamp
compartment is hot!
Allow 30 minutes to
cool down before
changing lamp!
Warning: To reduce
the risk of personal
injury, do not drop
the lamp module
or touch the lamp
bulb. The bulb
may shatter and
cause injury if it is
dropped.
© 3M 2008. All Rights Reserved.
Replacing the Lamp
The projector keeps track of the lamp usage. It will show
you a warning message:
When you see this message, change the lamp as soon as
possible. Make sure the projector has cooled down for at
least 30 minutes before changing the lamp.
1
Lamp Replacement Procedure:
1. Turn off the power by pressing the Power/Standby button.
2. Allow the projector to cool down for at least 30 minutes.
3. Disconnect the power cord.
4. Push up and remove the cover.
5. Use a screwdriver to remove the 3 screws from the lamp
module.
6. Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
2
3
Appendices
4
41