MSI NF720DT-C43 Series Manual page 27

Seral ATA Connector: SATA1~6
Ths connector s a hgh-speed Seral ATA nterface port. Each connector can connect
to one Seral ATA devce. SATA has three modes IDE, RAID and AHCI. SATA1~6 are
all avalable n RAID and AHCI mode, except when SATA connectors runnng n IDE
mode, the SATA5 and SATA6 wll be unavalable. (please refer to Chapter3 BIOS Setup
-> Integrated Perpherals -> RAID Mode)
Important
Please do not fold the Seral ATA cable nto 90-degree angle. Otherwse, data loss
•
may occur durng transmsson.
Fan Power Connectors: CPUFAN1, SYSFAN1/2
The fan power connectors support system coolng fan wth +12V. When connectng the
wre to the connectors, always note that the red wre s the postve and should be con-
nected to the +12V; the black wre s Ground and should be connected to GND. If the
manboard has a System Hardware Montor chpset on-board, you must use a specally
desgned fan wth speed sensor to take advantage of the CPU fan control.
Important
• Please refer to the recommended CPU fans at processor's offical webste or consult
the vendors for proper CPU coolng fan.
• CPUFAN1 supports fan control. You can nstall Overclockng Center utlty that wll
automatcally control the CPU fan speed accordng to the actual CPU temperature.
Fan cooler set wth 3 or 4 pns power connector are both avalable for CPUFAN1.
•
• SYSFAN1/2 support fan control, too. You may select how percentage of speed for
the SYSFAN1/2 n BIOS.
CPUFAN1 SYSFAN1/2
MS-7511 MS-7511
2-11