Safety Instructions; Safety Instructions Used In This Document - Grundfos AQtap Installation And Operating Instructions Manual

2. Safety instructions

The following safety instructions must be
observed during installation, operation and
servicing of the product. The safety
instructions will appear again in the
relevant sections.
Non-observance of the safety instructions
may have dangerous consequences for the
staff, the environment and the product and
may result in the loss of any claims for
damages.
Should you require further information,
please contact Grundfos.
2.1 Safety instructions used in this
document
DANGER
POISONING
Improper use can lead to personal
injury!
The AQtap dispenser must be used
with water complying with WHO
drinking water standards.
All parts and materials used in the
hydraulic system must be suitable
for drinking water appliances.
Improper use can lead to damage
to the equipment!
The AQtap dispenser must be used
with water complying with WHO
drinking water standards and
Caution
technical data.
The AQtap interface must only be
operated with smart cards and with
fingers.
6
DANGER
ELECTRIC SHOCK
Switch off the power supply, both
grid and solar, before making any
connections.
The AQtap cabinet must only be
opened by authorised and qualified
staff.
All electrical connections must be
carried out by a qualified electrician
in accordance with local
regulations.
Stripped parts of wires must not
protrude from terminals.
DANGER
ELECTRIC SHOCK
AQtap with grid power supply must
be connected to an external mains
switch with a minimum contact gap
of 3 mm in all poles.
If an AQtap with grid power supply
is connected to an electric
installation where an earth leakage
circuit breaker (ELCB/RCD) is used
as an additional protection, this
ELCB/RCD must trip when earth
fault currents with DC content
(pulsating DC) occur. The ELCB/
RCD must be marked with both
symbols shown below.