Tools And Material; Opening The Product; Mechanical Installation - Grundfos AQtap Installation And Operating Instructions Manual

4.3 Tools and material

The following tools and material are needed for installation of the
AQtap, they must be provided by the customer.
4.3.1 Tools
drilling device (d = ∅10 mm, l = 50 mm)
•
• water-level
• yard stick
• torque wrench
– torx TX25, TX10
– screwdriver for slotted screws
• adjustable spanner
• flat pliers
• cutter
• pencil.
4.3.2 Material
For the requirements for the material see sections
installation, 4.7 SIM card preparation and installation
4.8 Electrical connection
• outlet connector and hose
• 90 ° brass elbow, 3/4", male/female connection
• shut-off valve, 3/4"
• SIM card
• cables for the power input
– grid
– solar
– external battery
• all-pole disconnection switch
• fuses.

4.4 Opening the product

DANGER
ELECTRIC SHOCK
The AQtap cabinet must only be opened by
authorised and qualified staff.
To open the AQtap, unlock the upper lock with one of the unique
keys and the lower lock with the standard cabinet key.

4.5 Mechanical installation

4.5.1 Mounting the product
Fig. 1
4.6 Hydraulic
and
1. Choose an appropriate mounting place, see section
4.2 Location.
2. Mark the 4 drilling points at the mounting place according to
the drilling scheme.
3. Drill the 4 holes d = ∅10 mm, 50 mm deep.
4. Insert the 4 dowels in the drilled holes.
5. Screw the 4 screws into the dowels with an adjustable
spanner. The thread rod must point outwards, the wood screw
part must be completely screwed in.
6. Place the AQtap cabinet on the 4 screws, flat to the wall.
7. Place the 4 washers on the screws.
8. Screw on the 4 nuts with a torque wrench M8, torque 5 Nm.
360
400
Drilling scheme
11