Using Extension Cords; Preparations At The Workplace - Hilti WSJ 750-ET Original Operating Instructions

5

Using extension cords

WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged
while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
• Use only extension cords of a type approved for the application and with conductors of adequate gauge
(cross section). The power tool may otherwise suffer a drop in performance and the extension cord may
overheat.
• Check the extension cord for damage at regular intervals.
• Replace damaged extension cords.
• When working outdoors, use only extension cords that are approved and correspondingly marked for
this application.
Information on recommended minimum conductor cross-sections and cable lengths is accessible via a link,
in the form of a QR code, at the end of this document.
6

Preparations at the workplace

CAUTION
Risk of injury! Inadvertent starting of the product.
▶ Unplug the supply cord before making adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Fitting the saw blade
1. Press and hold down the saw blade release.
2. Push the saw blade (teeth facing the cutting direction) into the blade holder until it engages.
3. Hold the saw blade against the resistance and let the saw blade release return to its original position.
4. Grip and pull the saw blade to check that it is held securely.
6.2 Fitting the suction adapter
1. Connect the dust removal adapter to the opening in the product.
2. Press the suction adapter against the product from below until it engages.
3. Connect the vacuum cleaner hose to the suction adapter.
6.3 Fitting the guard
▶ Push the guard onto the product from the front until it clicks into place.
6.4 Setting the orbital action
The 4 orbital-action settings allow cutting performance and quality of cut to be adjusted to suit the material
to be cut.
The orbital-action adjustment lever is used to set the power tool to one of the 4 settings.
The lower the orbital-action setting, the finer and cleaner the cut edges will be.
The optimum setting can be determined by carrying out practical tests.
To determine the correct setting for the task to be performed, consult the information provided with the saw
blade.
Status
Position 0
Position 1
Position 2
Position 3
*377835*
2
3
4
5
377835
Meaning
No orbital action
Low orbital action
Medium orbital action
High orbital action
English 7