Table of Contents
Advertisement
Audio selector icon. Tapping this icon will cycle through the different audio
devices that are available in that zone.
1. Display audio (TV & speaker icon):
Provides volume/mute control for the display. Pressing and holding the TV
icon will reveal ARC options if supported and any audio inputs connected
to the MHUB.
2. AVR audio (AVR icon):
If the zone contains an AVR then volume/mute controls will be presented.
8
When selected, all volume commands will be directed to the AVR instead
of the display.
3. MHUB AUDIO (MHUB AUDIO icon):
A third tap will enable MHUB AUDIO volume control of speakers in that
zone if MHUB PRO 2.0 has been configured as a V&A/stack. In this mode,
volume buttons are replaced with an audio slider and an additional label is
displayed to inform the user what audio is being routed to the speakers.
Pressing and holding this icon will reveal a source selector menu allowing
you to switch to audio inputs directly connected to MHUB AUDIO.
Volume control: increase or decrease volume by using a slider (MHUB
AUDIO only) or tapping the "+" or "-" buttons. Tapping the mute icon will
9
reduce the volume to 0 or put the device in a mute state. Volume commands
are targeted depending on what audio device is active as per point #8.
Tap to access uControl and MHUB-OS settings for app and MHUB
10
configuration options.
Change zones by selecting the zone you wish to control here. If a blue
display icon appears then this means that there is display control in that
11
zone. Zones can be reordered or removed by pressing and holding on the
zone label and then clicking "Done" which appears near location #10.
Execute Sequence. If you have created a Sequence in MHUB-OS then you
12
can make it visible from uControl' s setting page. Tapping the Sequence
button will execute that Sequence anywhere in the property.
11
12
10
https://youtu.be/4qGYH4q0XEM
37
Advertisement
Table of Contents
