Power Up - HDanywhere MHUB U 4x1+1 40 Manual

Power up

This section describes the power up process for MHUB U (4x1+1) 40, operating in standalone mode (by itself). If you are creating a V&A/stack system then please consult
the MHUB AUDIO manual for detailed instructions.
Power up sequence for MHUB U (4x1+1) 40
1 Ensure that all devices are turned off.
2 Connect HDMI sources to the input ports on MHUB. If any sources require IR control, ensure that IR is connected at this stage as well.
3 Connect the display receiver to MHUB using Cat 6/7 cable in to MHUB' s video output port.
4 Connect any HDMI video outputs such as displays, AVRs or mirrored displays using HDMI cables from MHUB' s video output ports.
5 Connect MHUB' s audio output ports to speakers, AMP/AVRs or distribution hardware such as MHUB AUDIO.
6 Ensure that HDMI cables are fed from display receivers or HDMI IR Dongles in to their respective displays and that any IR hardware is connected as well.
If you are connecting to LAN via Ethernet then connect a cable between your router and the IP control port on your MHUB.
7 If you are using WiFi then you must activate Discovery Mode after step #11. (See pages 10 & 28).
Important: If you are connecting over WiFi then do not connect an Ethernet cable to MHUB.
Plug in the supplied power lead, MHUB will automatically power on and power will be fed to all display receivers. MHUB and any connected display receivers LED
8
indicators should be lit and solid.
9 Turn on each source device one after another followed by each display.
10 Ensure that displays are set to the correct HDMI input. Picture and sound from source devices will now be displayed on screen.
11 MHUB will start its power up sequence (this can take up to 120 seconds after step #8). Ensure this period has passed before proceeding to the next step.
12 Install uControl on your iOS or Android device and run the application.
13 Complete setup on uControl (see "Setup on uControl").
25