HDanywhere MHUB U 4x1+1 40 Manual page 10

MHUB U (4x1+1) 40 panel description
1. Source (IN): HDMI video input ports indicated by numbers.
2. Video (OUT): HDBaseT (RJ45) & HDMI video output ports. The HDMI output
(B) mirrors HDBaseT output port (B) and is not switchable independently.
18Gbps video will pass through both HDMI (uncompressed) ports whilst the
HDBaseT port will use TPC (compression) simultaneously. The HDBaseT port
has two indicator lights. Left light: solid means connection between MHUB and
display receiver is good. Flashing means that the connection is poor. Off means
that there is no connection detected. Right light: solid means HDCP is detected.
Flashing means there is no HDCP. Off means no HDMI signal is detected.
3. Source IR (OUT): Connect an IR TX to control corresponding HDMI inputs.
4. Display IR (IN): Connect an IR RX to send a remote (IR) control command
through MHUB to the corresponding display "IR" output. (Page 12-13).
5. Global (OUT): Connect an IR TX to enable remote (IR) control of an AVRs,
soundbars etc.
6. HUB IR (IN): Connect an IR RX to enable remote (IR) control of MHUB.
7. WiFi: Connect the detachable WiFi aerial to connect to LAN over WiFi.
8. IP: Enables TCP/IP control of MHUB over Ethernet.
9. RS232: Enables a PC or control system to control MHUB over serial.
10. Audio (OUT): Optical & 3.5mm Stereo Jack audio output mirrored ports.
Coax outputs multi-channel audio and the 3.5mm Stereo Jack outputs 2ch PCM
with no downmix.
11. Power: Connect the power supply to MHUB.
10 Help is only an email away: support@hdanywhere.com.
A. Power: LED indicator light. If this light is on and solid then MHUB has power
and is on. If this light is flashing, then MHUB is in Discovery Mode (see below) or
there is an error.
B. Source Selector: Selects a HDMI video input for output (A).
C. Source Selector: Selects a HDMI video input for output (B).
D. HDA Logo: IR window for Infra-red (IR) remote control commands.
Discovery Mode:
Press and hold Source Selector buttons marked "A" & "B" for 5 seconds
to put MHUB into Discovery Mode for WiFi setup. This will restore MHUB
back to default network configuration. You can not undo this action. During
Discovery Mode, MHUB's Power LED indicator light will start to flash. If you
do not complete setup in 10 minutes then MHUB will exit Discovery Mode.