Table of Contents
Advertisement
... From uControl, proceed to configure MHUB-OS' first boot process (Part 2)
1 . EULA & Privacy Policy
2 . Name your MHUB
3A. Define connections (Stack only)
3B. Split inputs (Stack only)
4. Name your source devices
5 . Create zones
6 . Assign outputs to zones
7 . Confirm zones
8 . Connect MHUB to HDA Cloud
9. Complete setup
End User License Agreements and Privacy Policy statements. You can not proceed with setup if these are not agreed
to first.
Provide a unique name for your MHUB so that you can identify it easily. In stack mode all detected MHUB devices will
appear here.
If your MHUB(s) are being setup in stacked mode then this is where you will define what outputs from your Master
MHUB system are being routed to inputs on your Slave MHUB system(s).
If you are using an audio splitter to split one or more audio sources to multiple MHUB systems then this is where this
relationship is defined.
Give each one of your source devices a unique name (eg "Sonos", "CD Player") so that you can identify and switch to
easily. If you are setting your MHUB up in stack mode then any inputs assigned in steps 3a & 3b will become locked
and unavailable to edit as their input is dynamic depending on the output of the master device.
A zone is a room or location in your property where outputs from MHUB terminate in (eg "Kitchen", "Living Room",
"Bar").
A zone can contain up to 1 output in total. However, zones are limited to supporting only one video enabled MHUB
output.
An opportunity to review your changes.
Register MHUB on HDA Cloud to access online services, to extend your warranty and to grant permission for remote
monitoring and management to take place if your MHUB has been installed by a HDA Pro. The email address must
belong to the owner of the MHUB device.
A final step before returning back to the main uControl interface.
29
Advertisement
Table of Contents
