Adjust Camera Plate - oConnor 1040 User Manual

Maintenance

Adjust Camera Plate

1
If movement is detected in the camera plate or the lock lever is to stiff,
the clamp must be adjusted. Release the clamp lever (turn clockwise)
and lift out the camera plate.
3
Replace the camera plate, the lever will snap in to the secure position.
21
2
Using a hex key, adjust the small grub screw (clockwise to tighten
the clamp and counterclockwise to loosen the clamp). Make small
adjustments of between 1/8 and 1/4 turns.
4
Push the clamp lever fully counterclockwise to lock the plate.
Check the plate for movement and adjust again if necessary.
The clamp lever should be operable with the pressure of just one finger.