Adjust Lock Levers - oConnor 1040 User Manual

Adjust Lock Levers

If the pan and / or tilt friction locks do not fully engage at the end of
the lock lever travel, adjust the lever position as follows:
1
1. Rotate the lock lever to the locked position.
2. The lock lever is attached by means of a screw. Carefully peel
away the lock label to expose the screw. Using Hex key, remove
the screw
3. Pull the lever off the hexagonal shaft, rotate it approximately 30°
away from the "locked" end of the travel, and reinstall it.
4. Tighten the screw. Reapply the lock label.
2
3
4
1 Lock Shaft
2 Tilt Lock Lever
3
Screw
4 Lock Label
Maintenance
20