Ultra Smooth Fluid Drag; Pan And Tilt Locks; Tilt Lock Pin; Illuminated Bubble Level - oConnor 2575B Operator's Manual

Operator's Guide - OConnor 2575D Pan and Tilt Head
WARNING!
Do NOT attempt to adjust the counterbalance crank below
0% or above 99% as damage could occur

Ultra Smooth Fluid Drag

Both the pan and tilt mechanisms incorporate OConnor's ultra smooth fluid
drag to ensure smooth movement. The pan drag adjustment knob is located
on the lower left rear of the head with its indicator wheel on the left side of the
head, and the tilt drag adjustment knob on the lower rear-right side of the
head with its indicator wheel on the right side end cover. Both controls are
continuously adjustable from 0 to 9.

Pan And Tilt Locks

Friction locks on each axis allow the head to be locked at any desired
position. The pan and tilt lock levers are on the left-side of the head with the
tilt lock above the pan lock for easy and seamless operation.

Tilt Lock Pin

The tilt lock pin on the left side of the head is used to lock the platform in a
horizontal position. The lock pin is actuated by a flip lever with red (locked)
and green (unlocked) label indicators.

Illuminated Bubble Level

The bubble level on the left side of the head can be illuminated by pressing
the bubble level illumination button. The light will go out after approximately
20 seconds.

Handle Mounting

Handle mounting rosettes are located at the front and rear of the head, on
both the left and right sides. A telesco ping extension handle is supplied and
is attached using the handle clamp, with angular adjustment available on the
rosette serrations. Additional handles, including a front
handle and accessories can also be installed.

Camera Mounting Platform

The camera is attached to the head by means of a side loading platform
mechanism. The mechanism is released by sliding the red clamp lock button
to the left while pulling out the platform release lever in a counterclockwise
direction. Once the release lever has been rotated about 90º, the red hook
OConnor Engineering
handle,
9
Randal
www.ocon.com