Safety Rules And Warnings; General Rules - SaMASZ KT 260 H Operation Manual

WARNING:
The frequency of lubrication of the articulated telescoping shaft should be
carefully adhered to. Points shown on Pict. 4 should be lubricated every 50
hours. The articulated telescoping shaft should also be lubricated before and
after longer periods of disuse.
• It is possible to use shafts with similar technical parameters from different manufacturers after
consulting SaMASZ.
ATTENTION:
Additional equipment must be purchased separately.
•
The manufacturer will equip the mower with connecting elements (brackets and supports)
used to install required lamps and signs. Integrated lamps and reflectors are mounted on
the warning board.
Congratulations on your mower purchase and we know you will be satisfied from its use.

4. SAFETY RULES AND WARNINGS

4.1. General rules

•
The front axle of the driving tractor should be adequately loaded to maintain balance. If
necessary use front wheel weights.
•
All manipulation of the hydraulic hoist control lever should be made only from the driving seat,
operating the hoist while outside the tractor is forbidden.
•
In tractors with electro-hydraulic control system (EHR) the hoist is operated with a button
outside the cabin of the tractor. During operation please remain especially cautious.
•
When changing the mower position from operating to transporting the AT shaft should be
removed completely or at least on the end connected to the PTO of the tractor.
•
Operating the mower without covers or the apron is forbidden. The mower should also not be
operated with a damaged or raised apron (there is a danger of the mower throwing hard
objects).
•
Mowing can only be started after the power take-off reaches a nominal speed of 1000 rpm,
•
The power take-off cannot exceed speeds of 1050 rpm.
•
There should be a safe distance between the mower and people, a minimum of 50 m. Utmost
care should be maintained while working in the vicinity of roads and streets.
•
Any servicing or adjusting of the mower must be done only after the engine and cutting discs
have stopped.
•
The condition of blade holders must be periodically checked. Any damaged or worn holders
must be replaced.
•
During transport on public roads all traffic laws regarding lighting and additional equipment
for the mower must be observed. During transport the mower should be equipped with
the removable light board and the triangular safety sign.
WARNING:
Any maintenance or repair of the mower should be done with the tractor engine
off, the cutting bar resting on the ground and all rotating parts must be at rest.
Operating manual
Rear disc mowers with central suspension
- with hydro-pneumatic or spring suspension
- 1 3 -