Setting The Timers - Victron energy Bluesolar-5 Manual

2. Test mode
This mode is the same as Dusk to Dawn. But there is no 10 minutes delay when
controller recognizes the starting voltage. The test mode makes it easy to check the
system.
3. ON/OFF mode
This mode is to turn ON and OFF the load manually.

4.5 Setting the timers

Timer 1 Setting
indicator
Timer 2
Setting indicator
Battery type
Setting Indicator
Figure 4-3 Setting operation indicating
Choose the required setting indicator by pressing the setting button.
When the timer 1 LED is on, press the setting button for more than 5 seconds, until the LED
display flashes. Then press the setting button until the desired number appears according to
the following table. The setting is finished when the display stops flashing.
Repeat the procedure for timer 2.
LED display
Setting button
19