Maintenance - Lippert Components Power Gear Owner's Manual

8. Again, check the slide-out awning. Some awnings must be manually locked before traveling.
9.
If so equipped, re-install transit bars.
10. Take the coach to an authorized dealer for service.

Maintenance

The slide-out system has been designed to require very little maintenance. To ensure the long life of the
slide-out system read and follow these few simple procedures.
Do not work on the slide-out system unless the battery is disconnected.
• When the room is out, visually inspect the inner slide rail assemblies. Check for excess build-up of dirt or
other foreign material; remove any debris or items that may be present.
• If the system squeaks or makes any noises, it is permissible to apply a light coating of silicone spray or
lithium grease to the roller and bearing sleeve ID. Remove any excess lubricant so that dirt or debris do not
build-up.
• DO Not lubricate the slide-out drive gears, gear racks, or roller O.D. as this will attract dirt or debris.
Rev: 04.04.19
Fig. 3
3/4
" Hex.
override
Motor
Leads
Fig. 4
0°
Page 5
Rotate approximately 30
degrees counterclockwise
to release motor brake.
CCD-0001615