Multiple Systems Turbine Installation - Primus Wind Power AIR 40 Owner's Manual

MULTIPLE AIR WIND TURBIEN WIRING:
It is possible to wire multiple AIR wind
turbines together. A typical multi-
turbine system is depicted in Fig. 11
There are two methods used to accom-
plish this task see below:
Method One (Recommended)
Fig. 11:
Wire each turbine as a "home run" to
the bus-bar. The wire size between the
bus bar and battery must be sized for
the full output of ALL turbines added
together. Wire sizing chart should be
referenced, a "home run" bus system
typically results in reduced wire costs.
Each individual turbine should have its
own stop switch and breaker (or Wind
Control Panel).
Method Two:
Each AIR wind turbine is treated sepa-
rately to the breaker or wind control
panel . Each turbine has its own wires,
stop switch and breaker and connected
directly to the battery.
+ -
Fig. 11 Multiple AIR wind turbine wiring configuration
AIR 40, AIR Breeze, AIR 30, AIR X MARINE and AIR SILENT-X are trademarks of Primus Wind Power 2013 Primus Wind Power Inc. AIR Owner's Manual 3-CMLT-2020-A 22