Huawei SUN2000 M0 Series User Manual page 32

SUN2000-(3KTL-10KTL)-M0
User Manual
(1) Bolt
(4) Flat washer
Avoid drilling holes in the utility pipes or cables attached to the back of the wall.
● To prevent dust inhalation or contact with eyes, wear safety goggles and an
● Clean up any dust in and around the holes using a vacuum cleaner and
● After removing the bolt, spring washer, and flat washer, level the front of the
● Partially loosen the nut, flat washer and spring washer of the two expansion
Figure 4-8 Installing the Mounting Bracket
Step 3 Install the SUN2000 onto the mounting bracket.
Step 4 Tighten nuts.
Issue 06 (2020-10-23)
D ANGER
NO TICE
anti-dust respirator when drilling holes.
measure the distance between holes. If large hole tolerance exists, position and
drill holes again.
expansion tube with the concrete wall. Otherwise, the mounting brackets will
not stay steady on the concrete wall.
bolts below.
Copyright © Huawei Technologies Co., Ltd.
(2) Nut
(5) Expansion tube
4 Installation
(3) Spring washer
25