NOTE: A standard steering wheel puller and
two1/4–28 x 3 or 4 in. long screws are required to
remove the clamp.
NOTE: Refer to Fig. 25.
1. Loosen the two screws (4) on the clamp (15),
working through the slot at the bottom of the clutch
housing (17).
2. Install two screws (B) of the tool (A) in two of the
threaded holes in the clamp. Tighten the screw (C)
until the clamp comes off.
3. Go to Reassembly, page 26, Step 3, or continue
below.
NOTE: Refer to Fig. 26.
1. Remove the capscrews (11) and lockwashers (12)
which hold the clutch housing (17) to the engine
(45).
2. Remove the engine key (14).
3. Pull off the clutch housing (17).
4. Go to Reassembly, page 26, Step 1.
Clamp
B
C
Fig. 25
Clutch Housing
11
Fig. 26
17
A
15
45
14
17
12
72
1
Torque to
1
125 in–lb (14 N.m)
0155
308269
25