Kenwood KDC-6080R/RV Instruction Manual page 23

entered change as listed below.
+ –
Press the DISC or DISC
character.
Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z (KDC-6080R/RV Only)
Numerals and symbols: 0~9 @ " ' ` % &
Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä ê
ë î ï ô ö û ü ñ ç © Æ › fi
(KDC-6080R/RV Only)
NOTE
The operation and characters that can be entered may change
as listed below, depending on the unit that is connected.
A press of the 38 button exits the disc name preset mode.
Operations can be followed again from Step 2 at a time such
as this, and the characters to be input are selected using the
procedure described below.
+ –
Press the DISC or DISC
character. Besides the alphabet (capital letters only) and
numbers, you can choose the following characters: /,
=, <, >, [ and ].
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
6
Press the NAME.S button.
The disc name is stored and the disc name preset mode is
cancelled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• The number of characters and discs whose names can be
stored will differ depending on the disc changer that is
connected. Please see your disc changer manual for details.
Up to 8 characters and 30 CDs can be registered with this unit.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
button to display the desired
+ - = , . / \ < > [ ]
button to display the desired
+ –
,
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the reset button erases the disc names stored in this
unit, but does not erase the names stored in a disc changer.
, *,
— 23 —