Connecting Cables To Terminals - Kenwood KDC-6080R/RV Instruction Manual

Connecting Cables to Terminals

Connector Function Guide
Pin Numbers for
Cable Colour
ISO Connectors
External Power
Connector
A–4 Yellow
A–5 Blue/White
A–6 Orange/White
(KDC-6080R/RV only)
A–7 Red
A–8 Black
Speaker
Connector
B–1 Purple
B–2 Purple/Black
B–3 Gray
B–4 Gray/Black
B–5 White
B–6 White/Black
B–7 Green
B–8 Green/Black
Fuse(10A)
Functions
Battery
Power Control
Dimmer
Ignition (ACC)
Earth (Ground)
Connection
+
Rear Right ( )
Wiring harness
–
Rear Right ( )
(Accessory1)
+
Front Right ( )
–
Front Right ( )
+
Front Left ( )
–
Front Left ( )
+
Rear Left ( )
–
Rear Left ( )
Battery cable (Yellow)
Ignition cable (Red)
A–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
Connector B
Rear right output (Red)
Rear left output (White)
Front right output (Red)
Front left output (White)
Antenna Conversion Adaptor (ISO–JASO) (Accessory3)
FM/AM
antenna input
KENWOOD disc changer/DAB control input/
Display Data Output Jack
Outputs data representing the unit's current state,
causing it to appear in the external display.
To connect to this jack, a converting adapter
(optional) is necessary.
NOTE
To connect the Disc changer or DAB unit,
consult each manual.
TEL mute cable (Brown)
Power control/ Motor antenna
control cable (Blue/White)
8 6 4 2
NOTE
7 5 3 1
If no connections are
8 6 4 2
made, do not let the cable
7 5 3 1
come out from the tab.
— 34 —
Antenna Cord (ISO)
Connect to the terminal that is
TEL MUTE
grounded when either the telephone
rings or during conversation.
NOTE
To connect the KENWOOD navigation
system, consult your navigation manual.
Connect either to the power control
P.CONT
terminal when using the optional
ANT.CONT.
power amplifier, or to the antenna
control terminal in the vehicle.