Transmission Frequency; Modulation Level; Data Transmission Speed; Touch Sensor Tone - Kenwood KOS-A200 Instruction Manual

Menu system
In Standby mode

Transmission Frequency

Setting the transmission frequency.
1
Select Transmission Frequency setting mode
Press the [5] or [∞] button.
Select the "FREQ" display.
2
Set the Transmission Frequency
Press the [4] or [¢] button.
Display Setting
"FREQ 87.9" 87.9 MHz
"FREQ 88.1" 88.1 MHz
"FREQ 88.3" 88.3 MHz (Original setting)
"FREQ 88.5" 88.5 MHz
"FREQ 88.7" 88.7 MHz
"FREQ 88.9" 88.9 MHz
"FREQ 89.1" 89.1 MHz
"FREQ 89.3" 89.3 MHz
"FREQ 89.5" 89.5 MHz
"FREQ 89.7" 89.7 MHz
"FREQ 89.9" 89.9 MHz
3
Enter Transmission Frequency
Press the [OK] button.
• If there is a strong broadcast station signal near the
current frequency, radio interference may occur. If it
occurs, change the frequency.

Modulation Level

Setting the modulation level of transmitter.
Display and Setting
"MOD LV1"
"MOD LV2" (Original setting)
"MOD LV3"
• When you play sources, if the volume is low
compared with that for FM increase the modulation
level. If the volume is high and there is distortion,
decrease the modulation level.
22
|
English

Data Transmission Speed

Setting the data transmission speed of RDS.
Display and Setting
"SCL-SPD 1"
"SCL-SPD 2"
"SCL-SPD 3" (Original setting)
"SCL-SPD 4"
"SCL-SPD 5"
• Sets the value that a text is displayed correctly by car
stereo.
In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound)
ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
"BEEP OFF" Beep canceled.

Touch Sensor Tone Volume

Adjust the operation check sound level (beep
sound).
Display and Setting
"BEEP LV1"
"BEEP LV2"
"BEEP LV3" (Original setting)
"BEEP LV4"
"BEEP LV5"
• The touch sensor tone volume can be set for each
source.
• AUX1 and AUX2 cannot be set a different value.