Accessories/ Installation Procedure - Kenwood KOS-A200 Instruction Manual

External media controller with rds encoder
Hide thumbs Also See for KOS-A200:
Table of Contents

Advertisement

Available languages

Available languages

Accessories/ Installation Procedure

Accessories
1
2
3
4
(Ø4 × 16 mm)
5
(Ø3 × 6 mm)
6
7
26
|
English
Installation Procedure
1. To prevent a short circuit, remove the key from
the ignition and disconnect the - battery.
2. Make the proper input and output wire
connections for each unit.
..........1
3. Connect the wiring harness wires in the
following order: ground, battery, ignition.
4. Connect the wiring harness connector to the
unit.
5. Install the unit in your car.
6. Reconnect the - battery.
..........1
2WARNING
If you connect the ignition wire (red) and the battery wire
(yellow) to the car chassis (ground), you may cause a short
circuit, that in turn may start a fire. Always connect those
wires to the power source running through the fuse box.
..........1
• If your car's ignition does not have an ACC position,
connect the ignition wires to a power source that can be
turned on and off with the ignition key. If you connect
the ignition wire to a power source with a constant
..........2
voltage supply, as with battery wires, the battery may die.
• If the fuse blows, first make sure the wires aren't touching
to cause a short circuit, then replace the old fuse with
one with the same rating.
• Insulate unconnected wires with vinyl tape or other
similar material. To prevent short circuits, also do not
..........1
remove the caps on the ends of the unconnected wires
or the terminals.
• After the unit is installed, check whether the brake lamps,
blinkers, wipers, etc. on the car are working properly.
..........1
..........2

Advertisement

Table of Contents
loading

Table of Contents