Table of Contents
Advertisement
Security
It is advised to erase all channels before you
sell or turn in your vehicle.
To do this, push and hold the two outside
buttons for 20 seconds until the orange indi-
cator flashes. Note that all channels will be
erased. Individual channels cannot be
erased.
The HomeLink® Universal Transceiver is
disabled when the Vehicle Security Alarm is
active.
NOTE:
The universal garage door opener only oper-
ates when the engine is running for security
reasons associated with removable tops and
doors.
Troubleshooting Tips
If you are having trouble programming
HomeLink®, here are some of the most
common solutions:
Replace the battery in the garage door
opener hand-held transmitter.
Push the LEARN button on the garage
door opener to complete the training for a
Rolling Code.
Did you unplug the device for program-
ming and remember to plug it back in?
If you have any problems, or require assis-
tance, please call toll-free 1-800-355-3515
or, on the Internet at
HomeLink.com
information or assistance.
WARNING!
Vehicle
exhaust
contains
monoxide, a dangerous gas. Do not run
your vehicle in the garage while program-
ming the transceiver. Exhaust gas can
cause serious injury or death.
Your motorized door or gate will open
and close while you are programming the
universal transceiver. Do not program
the transceiver if people, pets or other
objects are in the path of the door or
gate. Only use this transceiver with a
garage door opener that has a "stop and
reverse" feature as required by Federal
safety standards. This includes most
garage door opener models manufac-
tured after 1982. Do not use a garage
door
opener
without
these
features. Call toll-free 1-800-355-3515
or, on the Internet at
HomeLink.com
safety information or assistance.
General Information
The following regulatory statement applies to
all Radio Frequency (RF) devices equipped
in this vehicle:
for
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and
Economic
Development
license-exempt RSS standard(s). Operation
carbon
is subject to the following two conditions:
1. This device may not cause harmful inter-
ference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic Devel-
opment applicables aux appareils radio
exempts de licence.
autorisée aux deux conditions suivantes:
1. l'appareil ne doit pas produire de brouil-
lage, et
safety
2. l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi,
for
même si le brouillage est susceptible
d'en compromettre le fonctionnement.
Canada
L'exploitation
est
71
Advertisement
Table of Contents
