Heating; Cooling (With Air Conditioner) - Fiat 124 SPIDER 2020 Owner's Manual

Mirror Defroster (If Equipped): To turn on the
mirror defroster, place the ignition in the ON
position and push the Rear Window Defroster
Button.
5 – Air Recirculation Button
Push the Air Recirculation Button to select
between outside air and recirculated air posi-
tions.
Recirculated Air Position: (LED on) Outside
air is shut off when this position has been
activated. Use this position when going
through tunnels, driving in congested traffic
(high engine exhaust areas), or when quick
cooling of the vehicle is desired.
Outside Air Position: (LED off) Outside air is
allowed to enter the cabin. Use this mode for
ventilation or windshield defrosting.
NOTE:
Do not use the Outside Air Position in cold or
rainy weather; this is dangerous as it will
cause the windows to fog up. Your vision will
be hampered, which could lead to a serious
accident.
6 – A/C Button
Push the A/C Button to turn on the air condi-
tioner.
50
The LED on the switch will illuminate when
the Blower Control Knob is in any position
except the OFF position.
Push the button again to turn off the air
conditioner.
NOTE:
The air conditioner may not function when
the outside temperature approaches 32°F
(0°C).

Heating

Proceed as follows:
1. Set the Mode Selector Knob to the
position.
2. Set the Air Recirculation Button to the
outside air position.
3. Set the Temperature Control Dial to the
hot position.
4. Set the Blower Control Knob to the
desired speed.
5. If dehumidified heating is desired, turn
on the air conditioner.
If the windshield fogs up easily, set the Mode
Selector Knob to the position.
If cooler air is desired at face level, set the
Mode Selector Knob to the
adjust the Temperature Control Knob to
maintain comfort.
The floor vents will blow warmer air while the
side air vents will blow cooler air (except
when the temperature control dial is set at
the maximum hot or cold position).

Cooling (With Air Conditioner)

Proceed as follows:
1. Set the Mode Selector Knob to the
position.
2. Set the Temperature Control Knob to the
cold position.
3. Set the Blower Control Knob to the
desired speed.
4. Turn on the air conditioner by pushing
the A/C Button.
5. After cooling begins, adjust the Blower
Control Knob and Temperature Control
Knob as needed to maintain comfort.
position and