VIRTUFIT HTR 2.0 Ergometer Hometrainer User Manual
  1. Manuals
  2. Brands
  3. VIRTUFIT Manuals
  4. Exercise Bike
  5. HTR 2.0
  6. User manual

VIRTUFIT HTR 2.0 Ergometer Hometrainer User Manual

Hide thumbs Also See for HTR 2.0 Ergometer Hometrainer:
Table of Contents

Advertisement

Quick Links

HTR 2.0 Ergometer Hometrainer
User manual
EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HTR 2.0 Ergometer Hometrainer and is the answer not in the manual?

Questions and answers

Related Manuals for VIRTUFIT HTR 2.0 Ergometer Hometrainer

Summary of Contents for VIRTUFIT HTR 2.0 Ergometer Hometrainer

  • Page 1 HTR 2.0 Ergometer Hometrainer User manual...
  • Page 2 ADJUSTING THE BIKE ADJUSTING THE BIKE MAINTENANCE MAINTENANCE TROUBLE SHOOTING TROUBLE SHOOTING 15 - 19 CONTROL PANEL CONTROL PANEL 20 - 21 EXPLODED DRAWING EXPLODED DRAWING 22 - 23 PARTS LIST PARTS LIST TRAINING INSTRUCTIONS TRAINING INSTRUCTIONS VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 3: Safety Instructions

    – Before using the device, check that the nuts and bolts are securely tightened. – The safety of the device can only be maintained if it is regularly examined for damage and/or wear and tear. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 4 – Maintenance assembly and repair work not carried out by an official dealer. – In the event of improper use, neglect and / or poor maintenance. – Failure to maintain the device in accordance with the manufacturer’s instructions (see the enclosed manual). VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 5 Washers (15) as shown. Slip down Protective Guard (13) and fit in the place. • Attach the rear stabilizer (24) to the main frame (1) with the bolts (25) and washer (26) as shown. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 6 Connect the lower sensor wire (14) to the sensor wire extension (12) and attach then the handlebar bracket (11) on the main frame (1), using the bolts (7), the spring washer (36) and curved ring (15) as shown. Slide the protective cover (13) on the handlebar bracket towards down. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 7 Saddle (35) with ​ F lat Washer ​ ( 38) and ​ N ylon nut ​ ( 40), Horizontal Saddle Post (34), secured the screw and nut as been tightly attached to the Horizontal Saddle Post (34) VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 8 Attach the saddle (35) to the horizontal saddle post (34) through the screw and nut under the saddle with tightening a wrench. NOTE! Make sure the saddle (35) is securely attached to the horizontal seat post (34) before you start exercising. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 9 Attach the handlebar (5) to the handlebar bracket (11), put it in a suitable one position and then secure the handle with the dial (43), bolts (42) and spring washer (44).   VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 10 Attach the back cover (9) to the armrest (11) and fit the front and back heat the lid (6 and 9) correctly and store it in the crosshead (10) as shown. • Attach the top of the bottle (45) to the handle (11) and the crosshead lid (46) and washer (47). VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 11 • The adapter connection is located on the back of the device (see image). • Attach the adapter to the adapter connector and connect to AC power. • You can now use the exercise bike. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 12: Adjusting The Saddle

    To adjust the foot straps, first pull the ends of the foot straps off the tabs on the pedals. Adjust the foot straps to the desired position and then press the ends of the foot straps onto the lips. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 13: Daily Maintenance

    SEMI-ANNUAL MAINTENANCE • Inspect all bolts and nuts in connection with moving parts of the device, tighten as required. • Check the mobility of moving parts and components of the use equipment, silicone spray if necessary. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 14: Troubleshooting

    • The sensors may become damp, dirty or greasy. So you have to clean them regularly. The console is not working If there is no signal when pedaling, check if the cable is properly attached. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 15: Control Panel

    F1 is the best, and F6 is the toughest. Press this button to switch between the different functions: from RPM MODE (revolutions) to SPEED, ODO (total distance traveled) to DIST (distance), WATT (watts) to Calorie (calories) during exercise. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 16 The distance covered in the workout is displayed. CALORIES The calories burned from the beginning to the end of the workout. Your heart rate during exercise is displayed when using the heart rate sensors or a PULSE heart rate belt. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 17 Press “START” to continue the workout. The computer automatically adjusts the resistance, depending on the speed, to maintain the constant wattage value. You can use the “-” key to adjust the wattage value while exercising. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 18 It will take about 10 seconds for the resistance to increase or decrease. One of the workout data will count down to zero, it will make a sound and the workout will stop automatically. Press the “Start” “button to continue the workout. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 19 NOTE! One of the workout data will count down to zero (0), it will make a sound and the workout will stop automatically. Press the “START” button to continue the workout. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 20: Exploded Drawing

    EXPLODED DRAWING VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 21 EXPLODED DRAWING VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 22: Parts List

    Rear Stabilizer Nylon nut M8 Allen Bolt M8XL90 Belt Arc Washer d8X2 XΦ25 XR39 Hex bolt M5X60 Pop-pin Knob M16X1.5X32 Hex nut M5 Saddle Post Bushing Idler wheel Saddle Post Idler tube Knob Nut M10 Bolt VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 23 Thin nut M10×1 Spacer Φ16×Φ10.5×9 Spacer Φ16×Φ10.5×3 Flywheel axle Magnet Wave washer Φ12×Φ15.5×0.3 Power wire Tension Controller wire Motor Flywheel Small belt wheel Wave washer Φ17×Φ25×0.3 Small plastic cover Flange bolt M8 Chain cover 1pr. VirtuFit HTR 2.0 Ergometer Hometrainer...

  • Page 24: Training Instructions

    The purpose of cooling down is to return the body to its normal or near normal, resting state at the end of each exercise session. A proper cool-down slowly lowers your heart rate and allows blood to return to the heart. VirtuFit HTR 2.0 Ergometer Hometrainer...
  • Page 25 For questions or missing parts please contact your dealer.

Table of Contents