Kenwood X-W320 Instruction Manual page 33

Symptom
Recording is not initiated when the ¶ key is
pressed.
Noise level is high.
Sound is vibrating.
System remote control
Symptom
System remote control operation is not avail-
able.
1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function, and
not a malfunction.
Notes Notes
2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled.
Cause
The protection tab on the cassette has been
broken.
The cassette holder is not closed completely.
The recording level is set to the minimum
position.
The TAPE input selector is selected on the
amplifier.
Tape has been fully wound to a reel.
The head is magnetized.
External noise is induced.
The system assembly position is wrong.
The recording level was too low.
A tape recorded with Dolby NR ON is being
played with Dolby NR OFF.
The capstans or pinch rollers are dirty.
Tape is irregularly wound.
Cause
The remote control batteries are exhausted.
The remote control unit is operated at a too
large distance or from a wrong angle, or there
is an obstacle between it and this unit.
The audio cords and/or the system control cord
are not connected properly.
The player component is not loaded with a tape
or disc.
An attempt is made to play a tape using a
cassette deck which is recording something.
In case of difficulty
Remedy
Use a cassette with unbroken tab or close the
hole.
Close the cassette holder completely.
Adjust the recording level.
Press the input selector key of the source to
be recorded.
Change the tape transport direction of deck or
insert the tape inversely.
Demagnetize the head.
Install the system apart from other electrical
appliances and TV set.
Change the arrangement or the position of the
equipment.
Adjust the recording level.
Set the DOLBY NR key to B or C.
Clean the capstans and pinch rollers.
Wind the tape regularly by fast forwarding,
rewinding or playing it fully from one reel to
another.
Remedy
Replace batteries with new ones.
Operate the remote control unit in the correct
operation range.
Connect them properly.
Load a tape or CD in the player component.
Wait until recording is over.
X-W320 (En)
3 3