Kenwood X-W320 Instruction Manual page 30

A CD can be recorded with the one-touch "CCRS recording" by using the CCRS function built into this unit. This remote control
operation is possible only with the GRC. Please note that the edit recording (CCRS) is not possible with an LD player.
3 0
(CCRS : Computer-Controlled CD Recording System)
Preparation
1 (AV CONTROL CENTER's change inputkey
2 (Load a disc in the CD player.)
3 (Edit tracks as required on the CD player.)
4 Perform "Basic remote control opera-
Recording of CD playback (CCRS) (Deck B only)
GRC
1 Select the "CCRS" icon.
2 Press the ENTER key to enter the selec-
How to cancel CCRS
During recording level setting:
Press the Stop key of the CD player or the stop key
of the cassette deck.
During CCRS recording:
Press the Stop key of the CD player, then press the
OPEN / CLOSE key of the CD player.
After completion of CCRS recording:
Press the OPEN / CLOSE key of the CD player.
1. If the CCRS key is pressed during CD playback, playback stops and CCRS operation begins.
2. If the remaining amount of tape is small, CCRS may not function correctly or CCRS operation may be canceled in mid-operation.
3. Once the CCRS recording level has been set, the recording balance and recording level cannot be adjusted while the CCRS operation is
being carried out.
Notes Notes
4. The CCRS function sets the peak level for the entire CD in approx. 20~200 seconds. On very rare occasions, however, the function may
not be able to set the optimum recording level. If this occurs, carry out recording manually referring to the "Ordinary recording" section.
5. With CD players equipped with the EDIT function, it is possible to make recordings in which the last songs on sides A and B are not cut
off in the middle and in which the recording capacity of the tape is used to the fullest extent. (Set the REV.MODE key of the deck to "[".)
to CD.)
tion" (GRC only).
CCRS
tion.
§
Program-edit recording is not possible when tracks of more than one
CD are programmed using a Carrousel type CD player.
After recording, the cassette deck and CD player enter the stop mode
automatically.
System remote control operation
X-W320 (En)
^