Installation Without A Bridge (Standalone) - Lutron Electronics Aurora Z3-1BRL Advanced Installation Manual

Aurora

Installation Without a Bridge (Standalone)

1
Turn the desired lights OFF and then back ON
NOTE: This allows the lights to connect with controls for about
15 minutes.
2
Connect the light
6 sec
6
<4 in (10 cm)
While holding the Aurora dimmer as close as possible to
a
the bulb, press and hold the button on the Aurora dimmer.
The LED on the Aurora dimmer will begin to blink; continue
holding for approximately 9 seconds.
After approximately 6 seconds, the selected light will flash to
indicate which one you are connecting. If the light is correct,
continue holding the button down. If it is the incorrect light,
release the button and start over. Try holding the Aurora
dimmer closer to the light you are trying to connect.
Continue holding the button until the LED on the Aurora
b
dimmer begins to rapidly flash (should be about 3 seconds
after light flashed). When the LED stops flashing, Aurora is
ready for use.
Repeat steps a–b for all additional lights you wish to control
c
with your Aurora dimmer.
NOTE: If you want more than one Aurora dimmer to control the
same set of lights, see the Multi-location Setup Without a
Bridge section on the next page.
NOTE: When pairing an Aurora dimmer directly to multiple PhilipsR
HueR bulbs (standalone), it may be easier to pair each of the bulbs
one at a time in a table lamp before installing the bulbs in their
final location so that you are able to get the Aurora dimmer close
enough to the bulb. Additionally, having only one bulb powered
at a time will ensure that the desired bulb is paired to your Aurora
dimmer.
+3 sec
3
5