Panasonic CS-HZ25UKE Service Manual page 72

™

nanoe X check mode
To enable nanoe
o
™
During nanoe
o
™

nanoe X Abnormal Detection
Disconnection Abnormality
o
 Abnormal detection condition

Start from 1 sec after nanoe
signal is detected continuously for 5.9 secs.
 Action after abnormal detection condition fulfilled

Disconnection counters +1, nanoe
according to action mode and disconnection counter, below will be implemented:
During nanoe
o
counter ≥ 1. Abnormal code: H67 will memorized in EEPROM, Timer LED blinking and nanoe
LED Off.
Other Than Above: Disconnection abnormality will judged when disconnection counter ≥ 3.
o
Abnormal code: H67 will memorized in EEPROM and nanoe™ X LED OFF, Timer LED not
blinking.
 Disconnection counters clear condition >

Disconnection counter will be cleared when operation stop. (Not nanoe
™
nanoe X Discharge Abnormality
o
 Abnormal detection condition

After 30 minutes nanoe
 Action after abnormal detection condition fulfilled

Abnormal discharge counter +1, nanoe
abnormal discharge counter ≥ 12, abnormal code: H67 in analyze area (Area where abnormal code
not displayed) will be memorized.
 Abnormal discharge counters clear condition

Discharge counter will be cleared when operation become normal for 50 mins above or when
operations stop.
™
X check mode, during nanoe
Normal display mode
Press SW (t ≥ 0 secs)
When SW pressed continuously for t ≥ 5 secs to enter service zone
and press
SET
X check mode, H67 is judged when disconnection detected. Timer LED blinks.
™
X power ON, 6 secs has passed and in this 6 secs period, abnormal
™
X Check Mode: Disconnection abnormality will judged when disconnection
™
X power ON, abnormal signal is being detected continuously for 5s.
™
X operation ON:
SW's to choose function 57
Transmit
"NANOE™ X CHECK" code
™
X power OFF for 5 minutes and then restart. However,
™
X power OFF for 30 minutes and then restart. When
72
™
X Check Mode)
™
X