Mounting Rain Pelmet; Completing The Installation / Transfer To The Client - Helioscreen NEO Installation Manual

3.4. AWNING INCLINATION FOR THE "INCLINATION ADJUSTMENT" OPTION
with the "inclination adjustment" option, it should be noted
that with a greater change of inclination,
the arms are alternately shifted by a maximum of approx. 10°.
Care should also be taken that the drop profile
is positioned horizontally using the attached spirit level,
especially when retracting the awning.

3.5. MOUNTING RAIN PELMET

The supports for the rain pelmet have already been installed
when the brackets were mounted (Section 2.5.).
• After the system has been mounted, push the rain pelmet
from the front into the retaining bracket with both grooves
and straighten it. The flexible sealing lip pointing toward
the wall must face upward to prevent water from running
behind the awning.
• Tighten the clamping screws using a SW 5 Allen key.
• Fasten the side parts of the rain pelmet with cross-head
screws into the screw sockets of the profile.
Install the coupling in the same manner for coupled rain pelmets.
The coupling engages half of each profile.

3.6. COMPLETING THE INSTALLATION / TRANSFER TO THE CLIENT

• Clear site. Remove packaging materials from site and dispose according to local regulations.
• I n the event of queries at a later date, the order number and the product name must be recorded by the installer on the
operating instructions under "Product labelling".
• H and over to client all instructions concerning the installation and operation of the awning as well as the instructions for
the electrical connections of control units and switches.
Give client comprehensive instructions about the operation of the awning. Failure to observe the instructions and incorrect
operation can result in damages to the awning and accidents.
Notify client of the wind resistance class of the awning.
www.helioscreen.com.au | Phone 1300 766 319
Clamping screw
Helioscreen Neo • INSTALLATION GUIDE | 9
Sealing lip