Subscribe to Our Youtube Channel
Related Manuals for Helioscreen Vario-Pergola
Summary of Contents for Helioscreen Vario-Pergola
- Page 1 INSTALLATION INSTRUCTIONS VARIO-PERGOLA INSTALLATION INSTRUCTIONS VARIO-PERGOLA self supporting sunroof...
-
Page 2: Table Of Contents
2.7. MOUNTING RAILS AND POSTS ........................8 2.8. MOUNTING THE DISTANCE TUBE(S)......................10 2.9. ALIGNMENT OF THE SYSTEM ........................11 3. LINE SYSTEMS ................................ 12 4. INITIAL OPERATION ..............................13 5. DISMOUNTING ................................ 14 6. TROUBLESHOOTING .............................. 14 7. ANNEX..................................15 Helioscreen Australia Pty Ltd... -
Page 3: Safety
The safety-at-work and accident prevention regulations specific to each country must be complied with. In particular, a person performing special work at height must be suitably secured. The notes on the product and its packaging must be observed Helioscreen Australia Pty Ltd Page 3... -
Page 4: Installation
Hoist the awning exclusively in horizontal position and evenly. If the information above is not observed, the awning system may fall down and put the health of persons at risk! Helioscreen Australia Pty Ltd Page 4... -
Page 5: Mounting Situations: Wall And Ceiling Installation
approx. approx. 100 mm 100 mm 175 mm 75 mm approx. approx. 130 mm 130 mm Helioscreen Australia Pty Ltd Page 5... -
Page 6: Mounting Height And Position Of The Brackets
Helioscreen Australia Pty Ltd Page 6 Page 6 Art.-Nr.: 930059 © by WO&WO Literal mistakes and technical changes excepted... -
Page 7: Mounting Technique
To raise the awning turn counter-clockwise • If the inclination is corrected significantly, adjust the brackets alternately. • If the inclination is corrected significantly, adjust the brackets alternately. Valid from February 2010 Literal mistakes and technical changes excepted © bei WO&WO Art.-Nr.: 930059 Page 7 Helioscreen Australia Pty Ltd Page 7... -
Page 8: Mounting Rails And Posts
If required, slightly fix the pivot. • Re-install the cover of the guiding rail. • Insert the post profile with the pivoting bearing into the • Insert the post profile with the pivoting bearing into the base plate. base plate. • • Re-install the cover of the guiding rail. Re-install the cover of the guiding rail. Profile edge Profile edge Helioscreen Australia Pty Ltd Page 8... - Page 9 • Remove pulling cords for the fall bar. Adjust the Adjust the inclination of the brackets (the gap between inclination of the brackets (the gap between the the guide rail and the casing end cap must be uniform) guide rail and the casing end cap must be uniform) Helioscreen Australia Pty Ltd Page 9...
-
Page 10: Mounting The Distance Tube(S)
• Lock the nuts against the end caps of the distance tube. 2.10. alignment oF the SyStem • Align the system by moving the casing in the brackets or sideways movement of the two posts in the diagonal. Deviations of the diagonal measurements by more than 5 mm may result in malfunctions. • Vertically align the posts Helioscreen Australia Pty Ltd Page 10... -
Page 11: Alignment Of The System
2.8, it is necessary to fit the second pulling strap with the pulley. • For the installation, pull the fall bar of both systems on Helioscreen Australia Pty Ltd Page 11 the side of the centre guide rail approximately 100mm Chamfer in extended direction with the pulling strap, and then... -
Page 12: Line Systems
• Now remove the strap securing clips (4) and proceed • Now remove the strap securing clips (4) and proceed according to 2.8. according to 2.8. Page 11 Valid from February 2010 Literal mistakes and technical changes excepted © bei WO&WO Art.-Nr.: 930059 Helioscreen Australia Pty Ltd Page 12... -
Page 13: Initial Operation
If the test cable has not yet been connected, connect to the cable of the driving gear. Fully extend awning and check switch-off point. Electrical installation work and connections to the mains must be carried out exclusively by a licensed electrical company. Helioscreen Australia Pty Ltd Page 13... -
Page 14: Dismounting
When operated, system moves by jerks and jolts or generates indefinable noises Foreign bodies or lots of dirt in the channels of Clean guiding rails and spray lubricant on the guiding rails the rollers of the fall bar Helioscreen Australia Pty Ltd Page 14... -
Page 15: Annex
If the fall If the fall bar is parallel, the fabric tension should be roughly the same the same on either side. Page 14 Art.-Nr.: 930059 © by WO& Helioscreen Australia Pty Ltd Page 15...
Need help?
Do you have a question about the Vario-Pergola and is the answer not in the manual?
Questions and answers