Toshiba MMU-UP0091HP-E Service Manual page 198

No. Part name
⑥
Fan motor,
～ Continuance from the page in front ～
Fan,
Fan case
When replacing the fan motor, be sure
to exchange the clamp filter with the
fan motor lead wire.
⑦ Drain pan 1. Detachment
1) Remove the drain cap and then extract the drain water
accumulated in the drain pan.
NOTE
When removing the drain cap, be sure to receive drain
water using a bucket, etc.
2) Loosen screws which fix the bottom base. (For UP018
3 positions and UP036 2 positions)
Remove the fixing screws(2pcs.)at the center only for
UP036 Type.
3) As shown in the right figure, when sliding the bottom
base toward arrow direction,it opens using the hinge
part as a shaft.
4) Hold handle of the drain pan and then pull off slowly.
When removing the drain pan, do not hold the
drain socket. (Water leakage may be caused.)
2. Attachment
1) First hook the thin side of the drain pan to the discharge
port panel and then push in the thick side.
2) Close the bottom base and fix it with screws.
Procedure
CAUTION
CAUTION
Fan case (upper)
Discharge port panel
- 198 -
Remarks
Fixing screw
Hinge part as shaft
Bottom base
Screw
Do not hold the
drain socket.
NG
Drain socket
Drain pan
Handle