Connecting Electrodes And Cables; Connecting The Cables; Switching On The Tenstem Eco Basic; Selecting A Program - schwa-medico TENStem eco basic Instructions For Use Manual

Transcutaneous nerve and muscle stimulator
Hide thumbs Also See for TENStem eco basic:
Table of Contents

Advertisement

Connecting electrodes and cables

First connect the 2 mm diameter male connectors of the
cables (red and white connector on each cable) to the female
connectors of the electrodes (always 2 electrodes per cable).
Connecting the cables to the TENStem eco basic
Connect the white plug at the other end of the cable to the
sockets on the upper front face of the TENStem eco basic (no.
6). You may use the device with one or two cables depending
on the therapy. Now place the electrodes on the skin. In the
chapter "Electrode placements for pain programs" you can
find examples where to put on the electrodes. Generally the
electrodes should be placed directly on that area in which the biggest pain is. The TENStem
eco basic automatically recognizes if the electrodes are not adhered on the skin properly. In
this case it cannot be set to a high intensity, it automatically shuts off. Anyway you should
always take care of having placed the electrodes properly before you put on the TENStem
eco basic!

Switching ON the TENStem eco basic

Press
to switch ON the TENStem eco basic. A double beep sounds. The display indicates
the selected program, the therapy time, the frequency, the pulse width and the intensity.

Selecting a program

Press
P
until you have selected the program of your choice. Once you have reached P16 you
will return to P1.

Starting the stimulation / setting the intensities

Press the left
key to increase the intensity of channel 1.
Press the right
key to increase the intensity of channel 2.
Press the left
key to reduce the intensity of channel 1.
Press the right
key to reduce the intensity of channel 2.
It is not possible to adjust the intensity of both channels at the same time.

Stopping the stimulation

The stimulation stops automatically at the end of each program. You can stop the
stimulation manually at any time by pressing the
P
key or the
key.
11
English

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents