Memory Query Mode; Switching Off The Device - schwa-medico TENStem eco basic Instructions For Use Manual

14
schwa-medico Instructions for Use - TENStem eco basic
Pressing the right key increases the time by one hour (max. 23). Pressing the right key
decreases the time by one hour (min. 0).
Press the key to save all parameters and to leave the date/time mode again. Date and
time are continuously updated.
The TENStem eco basic switches OFF automatically after two minutes if no key is pressed. In
this case none of the adjusted parameters are saved.

Memory query mode

Only for devices from series C upwards:
First set the date and time (see above). The memory query mode is used to read out saved
therapy data from patients. By pressing and holding the left and E key for about 3 seconds
you enter the memory query mode. If no values are saved, the display shows "null" for about
2 seconds and the device returns to standby mode automatically. If you have saved therapy
data, the display shows the parameters of the last therapy session as shown below:
Used program P01
Frequency 100 Hz
Pulse width 200 µs
Therapy duration 0 min 44 s
Day of therapy 5 (fifth day)
Therapy session no. 3
You can save up to 90 therapy sessions respectively the first 3 of each day. With the left
key you can return to the values of the previous day (until you reach the first recorded day).
The left key lets you proceed to the next day (until you reach the current day). The right
key brings you to the parameters of the last therapy session of the respective day (until you
reach the first session of the respective day). The right key shows you the parameters of
the next therapy session (until you reach the last session of the respective day).
Pressing and holding the E button for about 5 seconds will delete
Resetting the memory
all saved data. The display shows "Clr" for about 2 seconds and the device can be used for
stimulation again. The TENStem eco basic switches OFF automatically after two minutes if
no key is pressed.

Switching OFF the device

Press the key to switch OFF the device. A single beep sounds. The TENStem eco basic
switches OFF automatically after 2 minutes if no key pressed and no stimulation has been
started.