Daihatsu TERIOS J100 Maintenance Manual page 19

e Check to see if the valve rocker arms of the No. 1
cylinder are free or are being pushed. According
to the table below, check and adjust the valve
clearance, using a thickness gauge.
Pistion position
When valve rocker arms of No. 1 cylinder are free:
(Piston of No. 1 cylinder is at top dead center under compression stroke)
When valve rocker arms of No. 4 cylinder are free:
(Piston of No. 4 cylinder is at top dead center under compression stroke)
NOTE:
·
The "O" mark denotes those valves that can be adjusted under that setting.
Valve Clearance (HOT)
0.25 ± 0.05 mm
Intake:
0.33 ± 0.05 mm
Exhaust:
(Reference)
Valve Clearance (COLD)
Intake: 0.18 mm
Exhaust: 0.25 mm
Tightening Torque (Lock nut):
r Turn the crankshaft 360 degrees (one turn).
t Proceed to check and adjust the remaining valve clearances.
(8) Installation of cylinder head cover
q Wipe off the oil from the gasket attaching surface
of the cylinder head.
w Check the cylinder head cover gasket for evidence
of damage.
Replace the gasket, as required.
CAUTION:
·
Install the cylinder head gasket in such a direction that
the identification mark may come at the intake side.
e Check the rubber grommets of the spark plug
tubes for evidence of damage.
Replace the rubber grommet, as required.
(For replacement of the rubber grommet, refer to
the EM section of the service manual.)
r Install the cylinder head cover gasket on the cylin-
der head.
NOTE:
·
Install the cylinder head cover gasket in such a direc-
tion that the identification mark may come at the intake
side.
16.7 - 22.6 N·m (1.7 - 2.3 kgf-m)
1
!
Inkate
!
Exhaust
Inkate
Exhaust
MA–19
JMA00051-00042
2 3 4
!
!
! !
! !
JMA00052-00000
JMA00053-00043