Daihatsu TERIOS J100 Maintenance Manual page 17

(9) Installation of spark plug
Install the spark plugs. Tighten them to the specified
tightening torque, using a suitable spark plug wrench
or the following SST.
SST: 09268-87703-000
Tightening Torque:
NOTE:
·
Since the insulator strength of a small spark plug is
comparatively smaller than that of a regular spark plug,
when tightening, be sure to use the tool exclusively
used for this application. Also, when tightening, never
use the wrench in a crooked way.
(10) Installation of ignition coils
Install the ignition coil on the No. 2 and No. 4 spark
plugs with the attaching nuts and tighten the nuts to
the specified tightening torque.
Tightening Torque:
CAUTION:
·
Never damage the boot section of the ignition coils by
interfering with the cylinder head cover.
(11) Connect the ignition coil connectors to the ignition
coils properly.
(12) Connect the resistive cords to the spark plugs and ig-
nition coils properly as shown in the figure.
NOTE:
·
Never interfere the resistive cord with the ignition coils
and attaching nuts of the ignition coils.
·
Never bend or twist the resistive cord beyond what is
necessary.
(13) Clamp the resistive cord to a clamp provided on the
ignition coil as shown.
(14) Installation of air cleaner
q Install the air cleaner case to the cylinder head
cover and throttle body with the three attaching
bolts and tighten the attaching bolts properly.
w Attach the hose band of the air cleaner duct which
is connected to the throttle body.
e Install the air cleaner element on the air cleaner
case.
r Install the air cleaner case cover and secure the
four clips.
t Connect the rubber hoses to the air cleaner case
cover.
14.7 - 21.6 N·m (1.5 - 2.2 kgf-m)
8.5 N·m ( 0.85 kgf-m)
MA–17
JMA00044-00035
DAIHATSU
16VALVE
JMA00045-00036
JMA00046-00037