Setup - NEC E328 User Manual

Setup

Setup
OSD Settings
Language
Transparency
Information OSD
Power save settings
Energy Mode
Power Save
Quick Start
Auto Power Down
Auto Input Change
None
First
Custom
HDMI Settings
CEC
EDID
Video Range
HPD Delay
Select the language used in the OSD.
Set the transparency level of the OSD menu between 30%, 50%, 70% and Off.
The higher the percentage, the more transparent is the OSD menu.
Displays or hides the Information OSD.
Information OSD contains the messages that are displayed on the screen when the input is
switched or when the state of the input signal changes.
Select a mode between Home, Retail, and Office.
For more information, see "Energy Mode"
Sets the time until the monitor enters the Power Save mode. When the set time has elapsed
after the input signal has been lost, the Power Save function is activated.
When set to [On], the monitor consumes more power but the display recovery time is
shortened when a video signal is input.
NOTEN
When the Quick Start function is enabled, if a signal is input into a terminal used


just before, the monitor enters into On Mode even if it was turned off using the
power button on the remote control or the main unit.
When turned On, the monitor turns automatically off after 4 hours without any operation.
When there are several inputs, this function switches automatically to the terminal to which a
signal is input.
Press the INFO button of the remote control to display the selected input terminal on the
Information OSD.
The input terminal is changed manually.
If the signal is lost in the input terminal being displayed, the monitor searches automatically
another terminal with an input signal and switches to it.
The display does not change if a new signal is input into a terminal different from the terminal
currently being displayed.
The input terminals included in the search performed by the monitor can be selected.
NOTEN If [Custom] is selected, the monitor will not switch to an input signal not set in


[Search terminal].
When the AV terminal and VGA (YPbPr) terminal are selected, the On mode is
not resumed even if a signal is input in the energy-saving mode.
This function makes it possible to control a device supporting HDMI CEC connected to the
HDMI terminal.
When set to On, HDMI CEC is enabled.
Sets the HDMI mode.
Mode 0N Max resolution is 1920 x 1080 (60 Hz).
Mode 1N Max resolution is 3840 x 2160 (30 Hz).
Mode 2N Max resolution is 3840 x 2160 (60 Hz), HDCP 2.2, or HDR.
Adjust the gradation range to be shown according to the video signal to improve the whiteout
and blackout of the image.
This function makes it possible to control the time until the video from the HDMI terminal is
displayed.
When set to Off, the time until the video is output can be reduced but the video may not be
output depending on the device. In such a case, set [HPD Delay] to On.
page 33.
English - 75