NEC E328 User Manual page 15

9. Adjust the picture settings
• When using video input terminals (HDMI1, HDMI2, HDMI3, Media Player), adjustment is not required.
• When using an HDMI input terminal, select the appropriate setting between [Mode 0], [Mode 1], and [Mode 2] in [EDID]
under [HDMI Settings] in the [Setup] OSD menu.
10. For long-term use
The backlight used for this monitor has a limited life and its brightness decreases with the usage time.
Also, if the same still image is shown for a long time, "Image Persistence" may occur. "Image Persistence" is a phenomenon
in which the image of an LCD remains visible after the image has been changed.
The "Image Persistence" is gradually eliminated by changing the screen, but if the same screen is shown for too long, the
"Image Persistence" will not disappear.
To avoid shortening the monitor's lifetime, consider the following:
• Turn off the main power of the monitor when not in use.
• Use the button on the main unit or the
• Use [Power Save] in the [Power save settings] in the [Setup] OSD menu. When there is no input signal, the monitor will
automatically switch to power save mode.
• If you cover the panel surface of the main unit with a protective cover made of glass or acrylic, the panel surface will be
sealed and the internal temperature will rise.
Use the computer's power management function or reduce the monitor's brightness to prevent the internal temperature
from rising.
• Use [Schedule] in the OSD menu to automatically turn the monitor on or in standby mode as required.
NOTEN When using the schedule function, be sure to set [Current Time settings] in the [Schedule] OSD menu.


11. Remote control sensor
Be careful not to damage the remote control sensor during installation.
button on the remote control to put the monitor in standby mode.
Remote control sensor
English - 12