Using The Remote Control; Installing The Remote Control Batteries; Learning About The Remote Control - Toshiba 27DF47 Owner's Manual

Using the remote control

Installing the remote control batteries

To install the batteries:
1. Open the battery cover on the back of the remote control.
2. Install two "AAA" size batteries. Match the + and – signs on the
batteries to the signs on the battery compartment.
3. Close the battery cover on the remote control until the lock snaps.

Learning about the remote control

POWER
turns the TV on and off
CHANNEL NUMBERS
RECALL
displays status information on-screen (page 17)
SLEEP
programs the TV to turn off at a set time (page 21)
MUTE
turns off the sound (page 22)
CH /
▲ ▼ cycles through programmed channels (page 14)
VOLUME + / –
selects or adjusts on-screen menus (page 13)
MENU/ENTER
programmed menu information (page 13)
EXIT
closes on-screen menus (page 13)
CH RTN (Channel Return)
(page 15)
PIC SIZE
cycles through the three picture sizes—4:3, 16:9, ZOOM.
(page 19)
INPUT
selects the audio/video input source (page 18)
ANALOG/DIGITAL
AUDIO
selects the desired sound (page 22)
30J-01(C)_EN.indb 12 30J-01(C)_EN.indb 12
allow direct access to channels (page 15)
adjusts the volume level
allows access to programming menus, and sets
returns to the last viewed channel
selects analog/digital mode (page 14)
Caution:
• Never throw batteries into a fi re.
Note:
• Be sure to use AAA size batteries.
• Dispose of batteries in a designated disposal
area.
• Batteries should always be disposed of with
the environment in mind. Always dispose of
batteries in accordance with applicable laws
and regulations.
• If the remote control does not operate
correctly, or if the operating range becomes
reduced, replace batteries with new ones.
• When necessary to replace batteries in the
remote control, always replace both batteries
with new ones. Never mix battery types or
use new and used batteries in combination.
• Always remove the batteries from the remote
control if they are dead or if the remote
control is not to be used for an extended
period of time. This will prevent battery acid
from leaking into the battery compartment.
POWER
CHANNEL
NUMBERS
SLEEP
CH ▲/▼
MENU/ENTER
CH RTN
(Channel Return)
INPUT
12
RECALL
MUTE
VOLUME +/-
EXIT
PIC SIZE
AUDIO
ANALOG/
DIGITAL
9/3/2550 16:37:40 9/3/2550 16:37:40